Airaid Filter Co. 26
88 E Rose Garden Ln. P
hoenix AZ 85050
(800) 498
-6951 A[email protected]m www.airaid.com Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter
is reusable and should be cleaned periodically.
13. Insert the remaining Grommet and Fitting into the
Intake tube as shown.
11. Using a standard screwdriver, carefully pry open the
clamp on the resonator diaphragm and remove the for-
ward half of the resonator.
12. Insert the Grommets and Aluminum Fittings into
the Airaid Intake tube as shown.
14. Insert the Mass Airflow sensor into the Airaid intake
tube as shown and secure it suing the #8 Button Head
Screws. Do Not Use the OEM hardware.
15. Insert the Intake Tube into the Hump Hose and
Reducer then tighten all 4 Intake Clamps.
Synthamax Air Filters do not require
oil. Service air filter as needed by
cleaning with common non-petroleum
all-purpose household cleaner and wa-
ter. Simple Green®, Formula 409® or
equivalent works great. Apply cleaner
to outside of air filter and allow to soak.
Then flush filter clean from the inside
out with a garden hose and repeat steps
if necessary. Do not apply high pres-
sure water or air to clean filter. Allow
filter to air dry and reinstall.
For your Oiled
media filter we
suggest using the
AIRAID Filter
Tune-Up Kit!
16. Reconnect the breather hoses to the Fittings in the
Airaid Intake Tube.
17. Connect the resonator to the Intake Tube as shown
using the supplied 1” Hose and the Speed clamps on both
ends.
18. Install the Airaid Premium Filter onto the Filter
Adapter inside of the Airbox.
19. Remove the protective film from the Lid and Win-
dow before installation. Install the Airbox lid and Win-
dow onto the Airbox, with the Window on top, using 6
sets of 1/4” Button Heads. and Washers.
20. Reconnect air flow meter and plug the wire harness
anchor into the Airbox wall.
10. Slide the Reducer and Clamps onto the throttle body
as shown.
Diaphragm
Fitting
Grommet
21. Double check your work. Make sure all clamps,
hoses, bolts, and screws are tight. Double check the hood
clearance. Reconnect the negative battery cable and rein-
stall the cover.
REV. 04.14.15
#64
#56
Forward Half
Grommets
Fittings
Airaid Screws
Resonator Delete Option: The resonator can be safely deleted if
so desired by capping off the Intake Tube with the supplied Cap
and Speed clamp. After removing the resonator assembly from the
firewall, insert the included Firewall plug to prevent debris from
entering the cabin.
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels